TPO Roofing in Auburn, Alabama

TPO Roofing in Auburn, Alabama

TPO roofing is the modern standard for flat commercial roofs, and it fits the Alabama climate well. The white membrane reflects the summer sun, stays strong through the storm season, and handles the heat that breaks down older materials. For businesses across Lee County, TPO is a workhorse.

Signs Your Auburn TPO Roof Needs Service

• Wrinkles or bubbling at the seams — the heat-welded joints are failing
• Water pooling near drains — slope or drain issues the membrane can’t fix
• Tears or punctures — foot traffic, debris, or hail damage
• Leaks at curbs and penetrations — flashings around vents and AC units
• Chalky or cracked surface — UV wear from the summer sun

Why TPO Works in Auburn

The Alabama climate is about heat and storms, and TPO handles both. In summer, the white surface reflects the sun, keeping the building cooler and slowing UV wear. In spring, the heat-welded seams create a strong water barrier that handles the heavy rain.

TPO also welds into strong seams. Those seams are the weak point on most single-ply roofs, so a proper heat-weld gives a business a roof that holds through the storm season.

How We Install TPO in Auburn

1. Prep the deck — clean, dry, and ready for insulation
2. Lay the insulation — rigid board with slope toward the drains
3. Roll and weld the membrane — heat-welded seams, factory-style finish
4. Flash the penetrations — curbs, drains, and wall edges sealed
5. Test and verify — a flood test confirms the roof is watertight

TPO Roofing Costs in Auburn

Service	Typical range	What’s included	Warranty
TPO repair	$600 – $2,300	Seam weld, patch, or flashing repair	2 years
TPO re-cover	$5,000 – $13,000	New membrane over existing roof	15 yr material
Full TPO replacement	$8,000 – $18,000	Tear-off, insulation, new membrane	20 yr material
Penetration flashing	$400 – $1,200	Curbs, drains, AC unit bases	2 years

Preventing TPO Problems in Auburn

• Keep drains clear — the storm season fills them fast
• Route foot traffic — use walkway pads where crews walk
• Check seams each spring — catch a failing weld before the storms
• Trim branches over the roof — limbs puncture the membrane and drop debris

TPO note: the seams are the roof. A good heat-weld beats any sealant, and in the Alabama heat, only proper welds hold up over time.

Serving Auburn and Nearby Areas

We install and repair TPO roofs for commercial buildings across Lee County — Auburn, Opelika, and businesses along I-85.

FAQ

Content above. FAQs are in frontmatter.

Start with a free TPO roof inspection and honest estimate. Call us today for local crews.